Work-holding specialist Hainbuch takes a comprehensive approach to zero-defect manufacturing. Stefan Nitsche, director main products, describes the basic requirements for clamping devices: they must be impervious to dirt and require almost no maintenance. Furthermore, they must offer very high rigidity and holding forces, with high concentricity accuracy offering deviations of no more than 5 µm, and minimal centrifugal losses.

Nitsche also recommends that users always use the right clamping device for the workpiece, even if this increases the set-up effort. For example, ID clamping is the best solution for five-sided machining. However, if the workpiece does not have the necessary clamping bore for this strategy, Nitsche believes that OD clamping with chucks is the ideal solution.

Says Nitsche: “We make use of our Centrotex quick change-over interface and Docklock zero-point clamping system to keep manual set-up times to a minimum – under one minute with our system instead of 30 minutes or so using conventional means – and change-over accuracy down to no more than 3 µm.”

Hainbuch’s measuring intelligence, which enables in-line process control, has been in successful use for over 15 years now; the company describes it as its third ‘zero-defect’ component. It checks the pre-machining clamping diameter down to the nearest micron, and detects the workpiece system.

“In addition, the actual clamping force on the workpiece is measured continuously,” says Nitsche.“As components gain in complexity, this represents a crucial process stability factor. We’ll be showcasing all three technologies and products live at the EMO 2023 exhibition in Hanover in September. Using Centrotex or Docklock, it’s child’s play to change over our clamping devices in seconds with microscopic precision, or use our IQ clamping devices for high-precision clamping while simultaneously performing various measuring operations.”
For further information www.hainbuch.com