Although recent years have seen the increasing prevalence of hard milling at Whitchurch-based toolmaker and plastic injection moulding specialist BM Injection, there will always be a place in its tool room for EDM technology, with both die-sink and wire-erosion machines in use.

To take advantage of the latest EDM capabilities, the company recently decided to introduce a second spark-erosion machine, ordering a Makino EDAF3 HEAT from UK agent NCMT, which at the same time supplied a Makino five-axis machining centre.
“Our latest Makino die sinker is compact and 100% reliable, even on demanding jobs,” states director Tim Combes. “Furthermore, the machine is capable of producing parts to accuracies measured in low single-figure microns. The level of intelligence built into the machine means that one toolmaker can operate both of our die-sink machines and the Makino five-axis machining centre. Deep ribs can be produced quickly, reliably and with low wear on graphite electrodes. Constant attendance for manual intervention to avoid the onset of arcing, for example, is not required due to the spark gap monitoring and arc prevention circuitry.”
BM Injection’s machine was supplied with Makino’s optional high energy applied technology (HEAT), which incorporates dual high pressure capability, digitally controlled flush pumps and a large capacity, four-step filtration system to provide fast machining speeds and accuracy, even under poor or difficult flushing conditions, says NCMT.
Offering capacity of 450 by 351 by 351 in the X, Y and Z axis respectively, the latest EDAF includes a newly developed flushing control and increased feed rates up to 5000 mm/min in X and Y.
For further information www.ncmt.co.uk